Tools

  • Mugen Seiki

    B0506 Mugen Seiki Snap Ring pliers

    These snap ring plies work great for all different sizes of “C” clips. The harden tips and a small angle to grab the clip and hold it tight while removing it from the part. Rubber handed for good grip. The pliers do have a coat of oil on them...

    $18.49
    Out of stock
  • Mugen Seiki

    B0549 Turnbuckle Wrench 4mm :MTC1

    Aluminum turnbuckle and camber adjusting tool. A great tool to make easy fine tune adjustments for both front / rear camber links and steering arm tie-rods. Will fit a 4mm turnbuckle. This tool will also work for the camber and steering tie-rods for the...

    $15.99
    Add to Cart
  • Flash Point Racing Products

    FP2117 FP 17mm Magnetic Wheel Wrench

    This is the Flash Point R/C 17mm Magnetic Wheel Wrench.  It’s a machined light weight 17mm wheel wrench that has a built-in magnet.  One end of the wheel wrench is open and allows you to remove the set-screws that hold the pin...

    $33.99
    Add to Cart
  • Mugen Seiki

    B0548 Rebound Stop Gauge (Droop)

    This is Mugen rebound stop gauge. This is a must have tool to measure the droop (length) of your shocks on your Buggy and Truggy. You can check shock droop (length) from 90mm to 135mm. A simple tool that is very easy to use. Check out the video to see it...

    $24.99
    Add to Cart
  • Mugen Seiki

    B0545 Pinion Gear Tool for MRX6R, GT7

    A universal pinion gear tool for both 1/8 on road and GT nitro cars with 2 speed transmissions. Included is an aluminum hub to hold and lock either 1/8 on road or GT clutch bell and a 2nd tool to install and tighten up both 1st and 2nd gear pinions onto...

    $44.99
    Add to Cart
  • Mugen Seiki

    B0542 Pinion Gear Tool: MTX6, 5

    A universal pinion gear tool for the MTX6R. Included is an aluminum hub to hold and lock the clutch bell and a 2nd tool to install and tighten up both 1st and 2nd gear pinions onto the clutch bell. This tool allows tightening the pinion gears without...

    $44.99
    Add to Cart
  • Mugen Seiki

    B0540 Height Gauge

    This is a high quality aluminum height gauge for both 1/8 and 1/10 nitro and electric cars. You can check the droop on both the front and rear of your car. Measurements go from -2 – 12mm. This tool needs to be used with B0529 or a set of chassis...

    $26.99
    Add to Cart
  • Mugen Seiki

    B0539 Height Gauge Spacer

    This is a set of high quality aluminum height gauge spacers. The spacers are 80 mm x 10mm. The spaces will lift the car perfectly off your flat surface 100mm to make so you can use a droop gauge to fine tune your car. They are used in conjunction with...

    $24.99
    Add to Cart